How To Lay Laminate Flooring Over Hardwood

You will lay the flooring lengthwise along this line.

How to lay laminate flooring over hardwood.

Press it against the expansion block. Pull up the existing flooring. Pergo made a big impact on the flooring market several years ago with its easy to install snap and lock installation and its. Can pergo laminate be installed over old existing hardwood floors.

Continue to the end of the wall using. Beginning at the longest wall put inch thick spacers between the wall and the first row of flooring. To decide which direction to lay the laminate wood floor planks consider which wall is the longest and straightest. Prepping a plywood subfloor for hardwood or laminate flooring introduction.

Typically you nail the transition strips to the subfloor so you need a gap of about an inch between the two flooring materials. Secure the first row of planks traveling lengthwise along the wall. If the new flooring does not have the built in underlayer simply roll out and tape your underlayment to the wood floor and begin installing the laminate. Hold the long side of the second row plank at an angle.

Figure on a 1 4 inch gap at each wall. Also using a pry bar and hammer remove baseboards to create. Start the second row where you started off the first. You are now ready to install laminate or hardwood flooring in your room or home.

Snap a line between the marks on the starting wall to form a guideline along the starting wall. Planks in the last row should be at least 2 inches wide. If you keep this in mind when you re laying the laminate floor installing the transition strips is easy. Check for flush by placing a straight edge against the tongue of the flooring.

Avoid a narrow strip against the focal point wall. Turn the grooved edge of the plank toward the spacers. This will stagger the seams which results in a more natural look. Laminate flooring can be installed directly over hardwood often with no preparation necessary.

Use the remainder of the laminate flooring planks you cut at the end of row one to start the next row as long as it s. Snap the second board at the end of the first. It s what you don t see that is the most important part of a beautiful long lasting hardwood or laminate.