How To Fit A Floor Mounted Door Stop

Then using your drill put the drill bit through the hole in the rod and make a shallow hole in the skirting board.

How to fit a floor mounted door stop.

If you do not have a template or installation instructions set the stop about eight inches away from the lock side of the door. The first step necessary to install a floor door stop is to locate the area in which it will be placed. They re easy to fix and the rubber part bounces the door off softly and quietly. If fitting floor mounted door stops then similar steps are required although marking out the fixing point will of course be on the floor.

Close the door on which you are installing the stop and use a flat head screwdriver to pry the hinge pin out of the top hinge. Then tighten down the screw. Find floor mounted door stop. Check out the products below.

2 place a pencil at the inside edge of the door on the side with the hinges and. Step 6 position the floor doorstop over the hole in the floor with the bumper of the doorstop pointing away from the wall. Also think about how far the stop should be from the wall. Tap the plastic anchor into the hole in the floor with a hammer if mounting to concrete.

If you re fitting door stops to ceramic tiled walls or floors then you may find our article on how to drill ceramic tiles helpful. After this open the door to the position where you want it to stop making sure there is sufficient clearance between the door and the wall. After removing the rod drill deep enough into the skirting board so that the screw will fit securely. 4 fit the hinge pin through the ring on the doorstop.

You should also leave between 10 15cm between the door stop and the wall behind allowing amble space so the door handles don t knock the wall. Ensure the doorknob is approximately 2 inches from the wall. Before you drill a pilot hole place the rod section of the door stop flush to the skirting board where you want to install it. Place the stop about 1 5 inches above the bottom of the door.

As part of this process determine whether you want to add a floor door stop to the wall or floor. Place the tip of the screwdriver underneath the flared top of the hinge pin and use the screwdriver as a lever to force it out. When you screw it in to the floor leave the screw a bit loose so the stop can pivot. If the door is a typical hollow core internal door it can flex quite a bit.

Open the door to the point where you want it to stop. Then gently open the door to the stop allowing the stop to square to the door.